#Zyxel nas326 ip serial

I already had a difficult time even getting the drive recognized since the findme. I just want a shared drive for two computers in my house without using any special software. Why is the WebDAV interface not working on my NAS326? Can this be done? I also don't want to use a browser based application for access. How about letting the script shutdown the box using telnet?January edited January in Questions. Theoretically you could log to a flash partition, but by doing so you are seriously? When you shutdown over telnet, with stick plugged and script running, everything is OK.

#Zyxel nas326 ip serial

The only way I can think of is the serial port. I was surprised that both harddisks didn't have contiguous nodes, as expected by timing at boot. If you remove a stick the node is freed, and when you plug it in again the node is reused. And all sata disks and usb mass storage devices use some scsi compatibility layer.

It's to be expected.Д«y default a new scsi device gets the first available free sd node. Isn't that strange? I assume you have 2 disks, so that is sda and sdc? Normally a stick in a 2 disk system is either sda or sdc, depending on which bus is scanned first. A kernel panic? I don't see anything in your script which can cause this strange behaviour. Ping is handled at kernel level, or even in the NIC itself, depending on hardware capabilities.

Are you sure about that? On my it is available. Is your usb stick listed before the raid array? In that case the array is still mounted if for some reason unmount stick fails. Are these leds all on when you start the shutdown? Could it be possible that the box is simply hanging in rc.

If the leds are still on, apparently the box fails to poweroff. I overlooked that gem in your first post.